- Description
- Additional information
- Brand
Description
4WTR-B System Sensor 4-wire, Photoelectric i3 Smoke Detector With a Thermal Sensor and Form C Relay.
The 4WTR-B System Sensor is a 4-wire, photoelectric i3 smoke detector with a thermal sensor and Form C relay. Throughout the i3 series, installation is simple with its installer-friendly base and plug-in design. The base accommodates a broad range of back box and direct mounting options and provides ample space for pre-wiring the device. To complete the installation, the i3 detector plugs into its base with a simple Stop-Drop N Lock action.
To reduce the likelihood of nuisance alarms, all i3 detectors are equipped with both drift compensation and smoothing algorithms. These capabilities minimize both short- and long-term causes of nuisance alarms, such as RF interference and dust accumulation.
When connected to the 2W-MOD2 loop test/ maintenance module or an i3 Ready panel, 2wire i3 detectors can generate a remote maintenance signal when in maintenance or freeze trouble condition. To measure the sensitivity of any i3 detector, the SENS-RDR displays the reading, in terms of percent-per-foot obscuration, within seconds.
i3 has red and green LEDs to simplify local status indication during power-up, standby, alarm, maintenance, and freeze trouble conditions. When in alarm, i3 sounder models generate an 85 dB temporal tone.
If connected to the RRS-MOD reversing relay/synchronization module, all i3 sounders on the loop will activate when one detector is in alarm. The RRS-MOD also synchronizes i3 sounder output to ensure a clear audible signal.
Should the application call for differentiating between a local and a general alarm, the i3 line offers an isolated thermal model, which initiates a local alarm when smoke is detected, and a general alarm when the thermal sensor is activated.
Technical Specifications 4WTR-B System Sensor
- Alarm Contact Ratings: 0.5A @ 30 VAC/DC
- Alarm Current: 35mA max.
- Auxiliary Contact: Form C
- Auxiliary Contact Ratings: 2A @ 30V AC/DC
- Detection: Photoelectric
- Dimensions: 2.0″ (51mm) H x 5.3″ (127mm) Dia.
- Freeze Trouble: 41F (5C)
- Heat Sensor: 135F (57.2C) fixed
- Humidity Range: 0% to 95% RH, noncondensing
- Maximum Ripple Voltage: 30% of applied voltage (peak to peak)
- Operating Voltage: 12/24 V non-polarized nominal, 10 min. to 35 max.
- Sensitivity: 2.5%/ft. nominal
- Standby Current: 50 A max. avg.
- Temperature Range: 32 to 100F (0 to 37.8C)
- Weight: 7.1 oz. (200 g)
- Wiring: 4-wire
- Wiring Gauge: 14-22 AWG
Datasheet 4WTR-B.
See all our parts for System Sensor
Additional information
| Weight | 0.6 lbs |
|---|---|
| Dimensions | 6.5 × 6.5 × 2.5 in |
| Product Brand | System Sensor |
| MPN | 4WTR-B |
| Product Category | 1871 |






























