- Description
- Additional information
- Brand
Description
4WTA-B System Sensor Photoelectric Smoke and Heat Detector / Sounder
The model 4WTA-B System Sensor is a 4-wire photoelectric smoke detector. All models incorporate a state-of-the-art optical sensing chamber and an advanced microprocessor.
The microprocessor allows the detector to automatically adjust its sensitivity back to the factory setting when it becomes more sensitive due to contaminants settling in its chamber. In order for this feature to work properly, the chamber must never be opened while power is applied to the smoke detector. This includes cleaning, maintenance, or screen replacement.
All models also feature a restorable, built-in, fixed temperature (135°F) thermal detector and are also capable of sensing a freeze condition if the temperature is below 41°F. Models 2WTA-B, 4WTA-B, 4WTAR-B, and 4WITAR-B contain a piezoelectric horn which generates the ANSI S3.41 temporal pattern in an alarm condition.
All detectors on a zone will sound when the power supply to them is reversed. The RRS-MOD can be used for the power supply reversal function. The RRSMOD also enables all the detectors’ sounders on a zone to be synchronized and allows the zone to be silenced from the panel by entering the alarm silence key at the keypad.
The detector that initiated the alarm condition will have its red LED and Form C relays (if applicable) latched until reset by panel. The model 4WITAR-B photoelectronic smoke sensor is isolated from the fixed temperature heat sensor, providing a self-resetting, local audible smoke alarm that does not alarm at the panel. Only the fixed-temperature heat sensor will cause the 4WITAR-B to initiate an alarm at the panel and the relay to change its state.
NOTE: In order for all i3 sounder detectors on a loop to sound when the panel alarms, the supply voltage polarity must be reversed. A reversing relay, System Sensor model number RRS MOD, must be used. The RRS-MOD is designed to allow all i3 Series detectors in the same loop to sound when one of the detectors goes into alarm.
In addition, the RRS-MOD will synchronize all of the i3 Series sounder smoke detectors on the loop. Some panels may require the use of programmable outputs. Refer to System Sensor literature for further information on the RRS-MOD. All i3 Series detectors are designed to provide open area protection. Two-wire models must be used with compatible UL Listed panels only
Datasheet 4WTA-B.
See all our parts for System Sensor
Additional information
| Weight | 0.4 lbs |
|---|---|
| Dimensions | 5.3 × 5 × 2 in |
| Product Brand | System Sensor |
| MPN | 4WTA-B |
| Product Category | 1871 |














